Get Hot Water Alabama

Water heater pilot light keeps going out in Alabama

One request and the search for a pro is handled.

Step 1 of 3: Equipment

A pilot light that keeps going out usually means a weak thermocouple, the small sensor that tells the gas valve a flame is lit. Once it wears out, it can't hold the signal long enough, so the valve shuts off gas to the pilot even though it was burning fine. A draft from a vent or door can also blow the flame out, and a dirty or partly closed gas supply can starve it. Less often, the problem is in the gas valve itself. Any of these can be checked and most can be fixed in a single visit. Since most homes in Alabama heat with electricity, your water heater may be the only gas appliance in the house relying on a pilot, so it's worth getting it sorted before you're stuck without hot water while keeping everyone at home comfortable.

A beige cylindrical water heater with copper pipes and a black drain pan stands in a corner of a basement with white walls, a concrete wall and small window at left, and a concrete floor.

Why the thermocouple wears out

The thermocouple sits right in the pilot flame, so it heats and cools every time the water heater cycles. That constant swing is what wears it out over time. A draft from a vent or a closet door can also blow the flame off the tip just enough to break contact. Either way, the gas valve reads it as no flame and cuts the pilot off, even seconds after you relit it.

A gray cylindrical water heater with two black access panels stands on a concrete floor against a white wall, with copper pipes and a flue above it and ductwork to the right.

What a gas valve actually does

The gas valve only has two jobs: let gas through to the pilot and main burner, or shut it off. It has no way to tell you why it shut off, so a pilot that won't stay lit and one that won't light at all can point to the same worn part. A licensed contractor checks the thermocouple's reading with a meter before replacing anything, since the fix differs if the valve itself is the one failing.

Thermocouple or Gas Valve: Which One

Thermocouple Problem

  • The pilot lights, stays lit while you hold the button, then goes out within a minute of letting go.
  • Soot or a film on the tip of the thermocouple can keep it from reading the flame right, even if the part itself is fine.
  • A contractor can test the thermocouple with a multimeter to see if it's still producing enough voltage to hold the gas valve open.
  • Replacing it is a straightforward job on most gas water heaters and doesn't require draining the tank.
  • If the pilot relights easily but won't stay on, this is the more likely cause.
  • Bending the thermocouple closer to the flame sometimes buys time, but it's not a fix.

Gas Valve or Draft Problem

  • If the pilot won't even hold while you're pressing the button, the gas valve itself may be the problem, not the thermocouple.
  • A gas valve has to be replaced as a whole unit, since the parts inside aren't sold separately.
  • Check whether the pilot goes out on windy days or right after a closet door swings shut nearby, since a draft can blow the flame off the thermocouple.
  • A blocked vent or flue can also starve the pilot of air it needs to stay burning.
  • Humid summer air in Alabama can affect how a marginal valve or sensor performs, especially in a closet or small space with poor airflow.
  • This kind of repair takes more diagnosis, since a local contractor has to rule out the thermocouple before pointing to the valve or venting.
A gray cylindrical water heater standing in a concrete-walled basement corner, with copper and white pipes and a metal flue running up to the ceiling, next to exposed wood framing on the left.

Pilot Holding Steady

This is what you want to see: a steady blue flame at the pilot, the burner lighting when a tap runs, and the tank holding hot water through a full load of showers. The thermocouple is doing its job, reading the flame and keeping the gas valve open.

A rusted cream-colored water heater with copper piping and a flue stands in the corner of a concrete-walled basement next to wooden shelving and ductwork.

Tank Showing Its Age

Rust and corrosion on the tank itself are a different problem than a pilot that won't stay lit, and worth mentioning to a contractor when you call. If the water heater looks like this, a repair might fix the pilot issue for now, but the tank is telling you it's near the end either way.

A cylindrical water heater with two access panels and copper pipes stands on a concrete floor against a painted concrete block wall.
Before you get your water heater repair
A white cylindrical water heater on a concrete pad in a basement, with copper and metal piping above it and a gray furnace cabinet with ductwork to the right.
After you get your water heater repair

Hand off the search today

Your request goes to one pro, not a list of companies.

No charge to send it. You decide if you hire them.

What a cold shower means here

Most homes in Alabama heat water with electricity, and if your water heater runs on gas with a pilot, it's likely the only gas appliance in the house. When the pilot won't hold, there's no backup plan for hot water. You notice it fastest at the end of the day, when everyone still needs a shower and the tank's gone cold. In summer the house is already working to stay comfortable against the humidity, and a cold start to a shower makes that worse before you've even left the bathroom.

Why relighting it yourself only goes so far

You can hold the pilot button down and get the flame going again, and it might hold for a day or a shower or two. But if the thermocouple is worn, it'll go out again, usually when you're not expecting it. Relighting it over and over doesn't fix what's failing, it just buys a little time. A contractor who works on these year-round can tell quickly whether it's the thermocouple, soot on the tip, or a draft problem, and get the flame holding for good.

A woman with long light-brown hair in a gray knit sweater sits in a living room looking off to the side, with a sectional sofa, houseplant, lamp, wooden table and large windows behind her.
A woman in a chunky gray turtleneck sweater sits indoors looking off to the side, with a blurred dining table, chairs, pendant lamp and window behind her.
A woman in a cream knit sweater with her hair in a bun stands near a window, looking off to the side, with a gray sofa, houseplant and open kitchen with pendant lights blurred behind her.
A woman with long brown hair in a cream knit sweater stands near a window, looking to the side, with a white sofa, shelving, and a hallway visible behind her.

Pilot keeps dying

You relight it, it holds for a minute, then goes dark again. Showers turn cold mid-stream and you're back to checking the pilot window every few hours.

Find a local pro

Thermocouple replaced

A contractor swaps the worn part and the pilot holds for good. Hot water runs through a full load of showers without you thinking about it again.

Find a local pro

Why does your pilot light go out at the worst time

You notice it when the water runs cold mid-shower, or when someone goes to wash dishes and nothing comes out hot. You check the pilot window and the flame is out again. Maybe you smell gas for a second when you relight it, or hear a faint click from the valve before it catches. Some nights it holds until morning. Other nights it goes out twice before dinner. If nobody catches it going out, the tank cools down and whoever showers next gets cold water with no warning. In a house with kids or older parents, that's not just an inconvenience, it's someone standing in a cold shower with no idea why.

A woman and a child wrapped together in a knitted gray blanket on a couch, with the child's head resting on her shoulder and a lit table lamp and houseplant in the background.
A smiling older woman with gray hair in a cream knit sweater stands in a dimly lit kitchen beside a window showing snow outside, with a round loaf of bread on the counter in the foreground.

67.4% of homes statewide heat with electricity

Most homes in Alabama run their heat on electricity, which means a gas water heater is often the one appliance in the house that depends on a pilot light at all. When that pilot won't stay lit, there's no other gas backup picking up the slack for hot water.

ACS 2020-2024 5-year B25040

The Fix Is a Known One

  • A pilot that won't hold almost always comes down to a worn thermocouple, and replacing it is a straightforward repair.
  • A contractor who works on water heaters all year in Alabama has seen this exact failure many times over and knows what to check first.
  • Calling in one licensed local contractor means one visit gets scheduled, not a round of calls from competing companies.
  • Once the thermocouple is swapped, the pilot stays lit on its own without you checking the window every few hours.
  • With electric heat running most homes here, a gas water heater is often the only thing standing between you and a cold shower, so getting the pilot fixed brings that backup back online.

A pilot that won't hold is almost always the thermocouple, and that's a part a contractor can replace in one visit. It's not a mystery and it's not a sign the whole water heater is done. The gas valve, the burner, the tank itself are usually fine. One worn sensor is telling the valve to shut off gas it shouldn't be shutting off, and swapping that sensor fixes it.

What makes this straightforward is finding someone who's seen it before. A contractor who services water heaters in Alabama year-round has replaced this part more times than they can count, and knows to check for soot on the tip or a draft blowing the pilot off before assuming the worst. That's the difference between a quick repair and a guessing game. When the request goes out, it goes to one licensed local contractor, not a handful of companies competing for the job. One visit gets scheduled. You're not fielding calls all afternoon trying to figure out who's actually coming.

Once the part is in, the pilot holds on its own. No more checking the window every few hours, no more relighting it and hoping. With most homes here running on electric heat, that gas water heater is often the only backup for hot water in the house. Getting the thermocouple replaced puts that backup back where it belongs, working without you having to think about it.

Sunlit corner of a room with a wooden sideboard holding a ceramic vase of olive branches and a dark wooden bowl, beside a white-framed window, a hardwood floor and woven rug.
A wooden cabinet holding a pale ceramic vase with leafy branches stands beside a beige wall in a sunlit room with hardwood floors, a jute rug, and a window showing green foliage outside.
Sunlit room corner with a beige upholstered sofa holding a rust-brown cushion, beside floor-length linen curtains at a window, over a wood floor with a woven rug.
Corner of a room with beige walls, a framed photograph, a floor-length linen curtain beside a window, an upholstered armchair with a knit pillow, white baseboards and trim, wood flooring and a pale rug.
Sunlit living room corner with a beige upholstered armchair with a cushion, linen curtains beside a wooden-framed window, green vertical panelled wall with a framed print, and a wooden table edge over a woven rug.

Finding a pro stops being your job

Only one pro gets your request, so you hear from one company.

Get a licensed local pro

You only hire the pro if you want to.